[. . . ] Power Mac G5 Access Panel Replacement Instructions Follow the instructions in this sheet carefully. Failure to follow these instructions could damage your equipment and void its warranty. [. . . ] Warning: After you shut down the system, the internal components can be very hot. Touch the metal PCI access covers on the back of the computer to discharge any static electricity from your body. (Figure 1) Important: Always discharge static before you touch any parts or install any components inside the computer. To avoid generating static electricity, do not walk around the room until you have finished working and closed the computer. 073-0809 Rev. Unplug the power cord. Removing and Installing the Access Panel 1. Hold the side access panel and lift the latch on the back of the computer. (Figure 2) Warning: The edges of the access panel and the enclosure can be sharp. Remove the access panel and place it on a flat surface covered by a soft, clean cloth. Install the replacement access panel by inserting the tab on the bottom edge of the panel into the channel in the bottom frame of the enclosure. Note: Make sure the latch is in the up position before replacing the access panel. [. . . ] Apple is not responsible for typographical, printing, or inadvertent errors. 1 Infinite Loop Cupertino, CA 95014-2084 USA + 1 408 996 1010 http://www. apple. com Apple, the Apple logo, Mac, Macintosh, and the Mac logo are trademarks of Apple Computer, Inc. , registered in the U. S. [. . . ]